What is Pelco default password

1. Modern Hardware (Sarix Pro 4, Spectra, Optera)

Most Pelco devices manufactured or updated in recent years do not have a default password.

• Initial Setup: Upon first access (via a web browser or VxToolbox), the system will be in a "Factory Default State."

• Forced Password Creation: You will be automatically redirected to a "New User" page. You are required to create a unique Administrator username and a complex password before the camera becomes operational.

• The "Big Team" Tip: Our installation specialists recommend a minimum of 12 characters, including a mix of upper/lower case, numbers, and symbols to meet 2026 compliance standards.

2. Legacy Hardware (General Access)

For older Pelco systems (legacy Sarix, IP110, or older Spectra models), the factory-shipped credentials were standardized:

• Default Username: admin

• Default Password: admin

3. Specialized System & Technical Access

If you are performing high-level systems engineering or troubleshooting via SSH (Secure Shell), the credentials differ:

• SSH/Linux Root Access (Endura, NSM5200, SM5200): * User: root

  • Password: pel2899100

• Legacy DVRs (DX4500/DX4600):

  • Firmware 1.2 or older: ADMINISTRATOR / 000000

  • Firmware 1.3 or newer: admin / admin

Technical Connectivity Defaults

If you are looking for the camera on your network for the first time, our Network Infrastructure Department notes the following default settings:

• Default IP Address: 192.168.0.20

• Subnet Mask: 255.255.255.0

• DHCP Status: Modern units will attempt to pull a DHCP address first; if a server is not found, they typically fall back to the .20 static address.

A Note on Cybersecurity: If you find a legacy device still using "admin/admin," our team strongly advises an immediate password update and firmware audit. Modern threats specifically target these known default strings.